SMR Gearbox Set up
Satisfactory overall performance depends on appropriate installation. lubrication and upkeep. as a result it is crucial that the guidelines while in the set up and upkeep leaflet. provided with each and every gearbox. are followed cautiously. a number of the vital elements of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as near to your reducer feasible, and mount reducer on driven shaft as near to bearing as practical. failure to accomplish this will trigger extra loads while in the input shaft bearings and output bearings and could result in their premature failure.
2. Install motor and wedge belt drive with all the belt pull at about 90° to the center line amongst driven and input shafts. this will likely permit tensioning of the wedge belt drive using the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm should be positioned the proper.
3. lnstall torque-arm fulcrum on a rigid help so that the torque-arm is going to be at somewhere around 
correct angles to the center line with the driven shaft along with the torque arm situation bolt. ensure that there exists ample consider up inside the turnbuckle for belt stress adjustment.
Keep near.
Bell drive could be positioned in any easy postion. if your torque arm is usually to be used to tighten the belts, the drive needs to be at about tight angle towards the line concerning the input and output shafts.
Bell drive could possibly be positioned to the appropriate if wanted.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that proven during the illustration.
Torque arm and belt consider up.
Torque arm might be mounted to your correct if preferred.
