Energy UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is created solely for that smaller lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit is broadly employed within the field of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled through the solenoid valve with all the pace controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Common Description
This energy unit is built exclusively for your medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, however the energy supply is lower, the decreasing motion is managed by the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Standard Description
This power unit is intended exclusively to the substantial lift table, Consisting of hugely effecient gear pump, 
AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed by a pressure compensated flow control valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This power unit is designed exclusively to the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve and also the pace controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power provide is lower, the reducing motion is controlled through the manual override perform.
Exclusive Notes
one. This electrical power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned before set up of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which should really also be clean and no cost of impurities.N46 hydraulic oil is advisable.
4. Oil transforming is required soon after the original one hundred operation hrs,afterwards when every single 3000 hours.
five. The electrical power unit proven is designed to be mounted vertically.
